You Will Need
Pattern
Tracing paper
Pencil
Ruler
Scissors
Six two-hole or shank buttons measuring from 5/8 to 7/8 inch across in colors of your choice (Carrie used four shank and two two-hole buttons)
12-inch-long chenille stems (pipe cleaners), two green and one orange
One sheet or scraps of green craft foam
2 x 5-inch piece of 1-inch-high green Styrofoam (or a piece of white packing foam painted green)
Black felt-tip marker
What to Do
1. For the flower stems, cut six 3-inch-long pieces of green chenille stem.
2. To make the flowers, add either a shank button or two-hole button to one end of each flower stem in the following way:
3. Trace the leaves pattern onto tracing paper and cut out. Lay this pattern onto the green craft foam and trace around its shape with pencil. Trace five more sets of leaves in the same way. Cut out the leaves.
4. Poke the bottom end of a stem through the center of a pair of leaves. Pull the leaves up so they are about 1/4 inch below the button flower. Add leaves to each stem in same way.
Worm: Cut one 2-inch-long piece of orange chenille stem. To form the worm's head, bend down the first 1/4 inch, then curl this same end down another 1/4 inch.
5. Use the black felt-tip marker to draw a dot on each side of the head for eyes.
6. Referring to the photo for position, push the flower stems and worm into the 2- x 5-inch block of green foam, pushing some pieces deeper so they appear to be shorter. Place drops of red and yellow food coloring randomly over frosting. With a spatula, blend colors randomly over frosting.
Leaves Pattern
Trace 1 -- tracing paper
Cut 6 -- green craft foam
Finished size: Button flower garden is 4 1/4 inches high x 5 inches long x 2 inches wide.
Thursday, April 9, 2009
Button Flower Garden
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment
Please leave your comment here ^)^